Rank: Member
Groups: Registered
Joined: 8/10/2011(UTC)
Posts: 3
|
I ordered a start relay kit for my refrigerator. The kit had 2 start relays that were the same. The instruction sheet shows both a Style 1 and a Style 2. Both of the relays I received were style 1. The old relay off of my refrigerator is just like the Style 2 shown in the instructions. Can I adapt the relay I received to fit my compressor?
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/10/2011(UTC)
Posts: 3
|
Originally Posted by: mdodson  I ordered a start relay kit for my refrigerator. The kit had 2 start relays that were the same. The instruction sheet shows both a Style 1 and a Style 2. Both of the relays I received were style 1. The old relay off of my refrigerator is just like the Style 2 shown in the instructions. Can I adapt the relay I received to fit my compressor? ----------
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
If you ordered the part AP3885081, it comes with two white boxes, one with a orange dot, the other with a black dot. The instructions call for selection based on the serial # of the fridg. If they did send two identical white boxes, send them back.
If your old relay is a black,small plastic ptc device, use the new one supplied, with the white klixon as the overload.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
