Hi Dean,

The belt is elastic. When reinstalling the belt, ensure the belt is positioned to track in the 7 outer grooves of the motor pulley. Turn the tub drive pulley and roll the belt on the pulley.

It's maybe a good idea to replace the belt.

- The belt Part number: WH08X10024

Hi Gene,

I have a WBVH6240FWW, and of course, similar issues to everyone else's problems, where the unit will no longer do any spinning. I have reset the control board, run through the self tests:

t01 - reset to #3
t02 - error code E54 only
t03 - cod 100, EE 13, inv 143
t04 - run through cycle 012, 123, 234, 345, 456, 567, 678, 789, 890 (all seemed to work)
t05 - displayed P and ran for about 1 min, then return to t05
t06 - ran to all levels and emptied, seemed fine
t07 - I did not perform
t08 - I did not perform
t09 - I did not peform
t10 - displays tt, does nothing, did not see any 120v reading at blue/red pins to inverter
t11 - shows 0, does nothing, no 120V at inverter
t12 - I did not perform
t13 - I did not perform
t14 - shows 0, does nothing, no 120V at inverter

I did check the motor resistance and shows 6 ohms across the three wire combinations, and sensor checks okay at 118 ohms. The only time I see 120V go to the red/blue input supply to the inverter is when I have the unit in normal run operation, start a wash cycle, the door will lock, unlock, lock, then the input to the inverter will slow ramp to about 112 V, then stop, then slow ramp again to about 112V, then stop, the drum will jerk slightly, and the unit will drain and stop working (flashing light on Start/Pause button).

I'm not sure if this leads to a bad inverter, or a bad control board output to the inverter. With a house of a wife and 3 daughters I need to make sure laundry can be done. Any help is appreciated!

thanks