Rank: Member
Groups: Registered
Joined: 7/8/2011(UTC) Posts: 2
|
Hi, My icemaker is working fine except it is overfilling. A ice formation forms from the maker to the ice tray and clumps many cubes together. I purchased and installed a WPL 67005154 water inlet valve from ApplianceParts Pros and it seems to have slowed the problem significantly but not eliminated it. Is there anything else that can cause this problem or did I get a defective valve?
thanx
chip
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 11/2/2009(UTC) Posts: 197
|
One thing I always check is that the refrigerator is level ... If the ice maker fills more on one side than the other it will over flow.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/8/2011(UTC) Posts: 2
|
Gabe
thanx for the input. The frig is deal level, right on the bubble, front to back and side to side. I have looked at the icemaker itself its flush down on the mounting screws. But the water does drip off the front of the icemaker. The cubes are also all the same size.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close