Rank: Member
Groups: Registered
Joined: 1/8/2009(UTC)
Posts: 5
|
Tested the switch. I have a digital meter. The meter just stayed showing a 1 .. Sorry never have used one before. Would this be correct in assuming it's ok. My dryer wants to shut off when you let go of the start switch. You usually turn the knob and the dryer begins and then continues to run. All seems well except it wants to turn right back off when you release the knob. Thanks again!:confused:
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638
Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
|
Do you have a wiring diagram?
If not open up the control console and see if there is one in there.
The switch seems to work as the motor starts.
Without seeing the wiring diagram, it sounds like a timer problem.
Try different cycle types.
On meter usage. Set it to ohms. Then short the leads together. It should go to 000 or real close. Now you know what a dead short or closed contact should be (0 ohms). There is a good sticky at the start of this forum on meter usage. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
