Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
flabbyman  
#1 Posted : Thursday, October 2, 2008 7:19:48 AM(UTC)
flabbyman

Rank: Member

Groups: Registered
Joined: 10/2/2008(UTC)
Posts: 2

:confused: Help me;

Before we were married my wife bought this Kenmore 90 plus series washer model # 110.28942890. When we married and moved to where we are now there wasn’t much use for it, so it has been out in the garage for about 2 yrs. Now the washer that was here went we went and brought her washer in. I hooked it up and found out it leaks.
I now have two problems.:confused:
1). I can’t figure out how the panel comes of for me to watch it while it goes though the cycle.

2). I have looked underneath it and it looks like it is leaking above the drain hose. There is a blue part with hoses come out of it, but I can’t see up there very well to tell were the leak is coming from.

Can any one help me????????
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
libertyappl  
#2 Posted : Thursday, October 2, 2008 8:17:19 AM(UTC)
libertyappl

Rank: Advanced Member

Groups: Senior Expert
Joined: 8/13/2008(UTC)
Posts: 3,097

There should be 2 clips about 2 inches from the corners, between the top & front panel, use a putty knife or similar toll to release these clips. Then you can raise the top and remove the front panel to see what is going on.
Without looking I am going to guess, since it was stored in the garage it's probably the pump had frozen and busted it. (should be part 3363394)
I haven't looked at your breakdown yet, so this is a guess. I'll take a look and see what else I can.
Let me know what you find.
Nat
flabbyman  
#3 Posted : Monday, October 6, 2008 6:40:07 AM(UTC)
flabbyman

Rank: Member

Groups: Registered
Joined: 10/2/2008(UTC)
Posts: 2

I'm sorry, but my washer doesn't have a front panel. It has a whole front and side panel.
libertyappl  
#4 Posted : Monday, October 6, 2008 8:38:38 AM(UTC)
libertyappl

Rank: Advanced Member

Groups: Senior Expert
Joined: 8/13/2008(UTC)
Posts: 3,097

Ok, on that model the cabinet should slide forward a little then tilt off.
Nat
Users browsing this topic
Guest (4)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.