Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
fran18346  
#1 Posted : Wednesday, October 1, 2008 1:20:30 PM(UTC)
fran18346

Rank: Member

Groups: Registered
Joined: 10/1/2008(UTC)
Posts: 3

This dryer, will light up but a few seconds later the flame goes out. I am not sure just where to start. Where might i be able to get a schematic, I can follow one. can someone head me in the right direction?
thanks
fran

I hate to say this but I repair commercial machines, but these 'home' type can get confusing.

wait, i just found the parts diagram...
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
libertyappl  
#2 Posted : Wednesday, October 1, 2008 1:51:56 PM(UTC)
libertyappl

Rank: Advanced Member

Groups: Senior Expert
Joined: 8/13/2008(UTC)
Posts: 3,097

Your wiring diagram should be in your control panel.
Nat
iamigor5@yahoo.com  
#3 Posted : Wednesday, October 1, 2008 1:52:39 PM(UTC)
iamigor5@yahoo.com

Rank: Advanced Member

Groups: Senior Expert
Joined: 8/17/2008(UTC)
Posts: 51

i would check the vent first to make sure its clean if dirty will cause it to short cycle,if thats not it check the solenoids on top of gas valve
fran18346  
#4 Posted : Wednesday, October 1, 2008 3:05:26 PM(UTC)
fran18346

Rank: Member

Groups: Registered
Joined: 10/1/2008(UTC)
Posts: 3

Ok for the real quick reply, I'll check both, i'll get back to it next week..

thanks

fran
Users browsing this topic
Guest (3)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.