Rank: Member
Groups: Registered
Joined: 10/1/2008(UTC)
Posts: 3
|
This dryer, will light up but a few seconds later the flame goes out. I am not sure just where to start. Where might i be able to get a schematic, I can follow one. can someone head me in the right direction?
thanks
fran
I hate to say this but I repair commercial machines, but these 'home' type can get confusing.
wait, i just found the parts diagram...
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 8/13/2008(UTC)
Posts: 3,097
|
Your wiring diagram should be in your control panel.
Nat
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 8/17/2008(UTC)
Posts: 51
|
i would check the vent first to make sure its clean if dirty will cause it to short cycle,if thats not it check the solenoids on top of gas valve
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/1/2008(UTC)
Posts: 3
|
Ok for the real quick reply, I'll check both, i'll get back to it next week..
thanks
fran
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
