Rank: Member
Groups: Registered
Joined: 7/12/2010(UTC)
Posts: 7
|
I have previous post on here dealing with this model not filling. I have model #587.14432200. When I did a parts search, this specific model # is not listed. Would anyone know of a comparable model # that is listed for parts? Also, I am looking for a sump gasket. The one I have is leaking. Also, it won't fill completely. And I have water that is coming out of the drain hose while the unit is running. Any help greatly appreciated.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Which parts, besides the pump (sump) gasket, are you looking for? It does not fill properly more likely due to a clogged water inlet valve. The drain hose should be at least 20" above the ground level. - The pump gasket Part number: AP2109490
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/12/2010(UTC)
Posts: 7
|
Thanks Gene,
I appreciate the info. I will order the parts.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/12/2010(UTC)
Posts: 7
|
I found out the leak was coming from the motor/pump shaft seal area. Is there amy way to just order the seal? I notice a lil' side to side play with the shaft going into the pump housing. Is there a bearing that can be ordered also? I ran the part number of the motor and it only showed the whole assembly (pump and motor assy). Thanks for you help.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Yes, you can order just the seal assembly, but there are no any bearings. - The seal assembly Part number: AP3209244
Gene.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/12/2010(UTC)
Posts: 7
|
Gene,
Thanks again. I appreciate your help. Having problems getting the old shaft seal off. Any helpful hints? I don't want to damage the pump housing or motor. Just about tried everything.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Very likely the motor shaft is rusted due to the water leak. Try to use WD-40 or something like that. If it would not help and the motor shaft is rusted beyond repair, the whole pump and motor assembly has to be replaced. - The pump & motor assembly Part number: AP3885612
Gene.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
