Rank: Member
Groups: Registered
Joined: 3/31/2015(UTC)
Posts: 9
|
Good evening.
The unit powers up.
All the functions on the control panel appear set when selected.
It is not throwing any error codes.
I have already disassembled once.
Continuity has been checked on the thermal fuses and thermostat. There appears to be a total of 4.
Thermal fuse part# 6931EL3003D was bad and has been replaced.
The resistance on the heating element was checked. I observed 20 AB, 20 BC and 50 on AC if I recall correctly. According to LG that 50 should be below 10.
I checked the strings and they looked good.
Any advice would be appreciated.
Thank you.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/31/2015(UTC)
Posts: 9
|
Just tested the continuity on the door switch.
It appears to be dead.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/8/2010(UTC)
Posts: 1
|
I don't see it - so I have to ask , 240 volts from black to red, L1 and L2 ? Belt switch made up? Is the problem it will not start to spin ??
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 11/10/2018(UTC)
Posts: 0
|
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/31/2015(UTC)
Posts: 9
|
Originally Posted by: RobertSD  I don't see it - so I have to ask , 240 volts from black to red, L1 and L2 ? Belt switch made up? Is the problem it will not start to spin ?? I did not do a voltage test on the heating element. Just a continuity test. As stated earlier I have already found a bad door switch and thermal fuse. I have not tested the belt switch as of yet. The unit does nothing when I start the cycle. The LED does say drying. Edited by user Sunday, November 11, 2018 5:36:40 AM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/31/2015(UTC)
Posts: 9
|
Replaced the switch. The one on the door was def dead. I checked the continuity on the new one. Both sides are alive. Where as on the old one, one side was dead. Still nothing. However when I push the start button I do hear something. It says drying. So it could be strings heating up. I noticed the check filter indicator is on. Everything is clean there. Advice? Ideas? I have not checked the drum switch as of yet. Edited by user Friday, November 16, 2018 10:21:57 AM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/31/2015(UTC)
Posts: 9
|
Problem solved.
The vast amount of assistance provided has been greatly appreciated.
#Sarcasm.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
