Rank: Member
Groups: Registered
Joined: 10/9/2018(UTC)
Posts: 4
|
Long story short - my wife decided I should try to find out why our dishwasher isn't performing like it used to.
I managed to disassemble as far as getting some kind of fine filter housing exposing a little stainless propeller looking think. But there was a bit of standing water with 2 little plastic balls floating.
After doing some reading I know they are "check balls", but where are they supposed to go?
Thanks
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/9/2018(UTC)
Posts: 4
|
Or perhaps where I could access a parts explosion picture?
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/9/2018(UTC)
Posts: 4
|
Originally Posted by: ohm  Thanks for that. I actually found a different video that helped me out - but now have another problem. I got everything back together, test ran it and seemed good. But then I found a very thin plastic washer on the floor where I had placed all the parts. Looking at a explosion drawing I found it wasn't there. Any idea where it goes , or should I start tearing it back apart trying to figure out where it should go?
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/9/2018(UTC)
Posts: 4
|
That's it. Got it back in it's place. Thanks so much for your assistance!!
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 9/29/2018(UTC)
Posts: 17
|
Originally Posted by: ohm Like in this screen shot.It's called the nozzle bearing! +1 
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
