Rank: Member
Groups: Registered
Joined: 1/6/2018(UTC) Posts: 1
|
I have an over the range microwave that has started behaving oddly.
If you start the microwave in normal (100%) mode, the magnetron delays coming on by exactly 60 seconds. The fans etc. run as normal, it just won't heat until after 60 seconds have elapsed. After that, it heats normally.
If you start the microwave in (any) reduced power mode, it begins heating immediately, and cycles on/off based upon the power setting selected.
I suspect the control board, but that part is more expensive than replacing the unit. I was wondering if maybe there could be another culprit.
Thanks! Jim K
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 7/27/2010(UTC) Posts: 1,395 Location: near the middle of nowhere Was thanked: 24 time(s) in 24 post(s)
|
you could try disconnecting the power for 5 minutes and see if that resets it.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close