Rank: Member
Groups: Registered
Joined: 11/29/2016(UTC) Posts: 2
|
My Dishwasher stopped working and I could smell some burning so I took the door off and found the attached. The burned connectors on the left look bad. I'm assuming I will need a new control board, will I also need to replace the harness-type thing there? Here are the images Kitechnaid control boardThanks in advance!
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 7/27/2010(UTC) Posts: 1,395 Location: near the middle of nowhere Was thanked: 24 time(s) in 24 post(s)
|
If you don't fix the wiring connector, it will burn up the same connection on your new board.
Electrical connections need to be clean and tight.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 11/29/2016(UTC) Posts: 2
|
Thanks for the reply. I'm also pretty curious why this would happen. In the first place.
I run the dishwasher and the disposal on a single 20a circuit. My electrician said that this wasn't a problem but I'm starting to question that.
Thanks
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close