Not Cooling refrig. or freezer - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! You can not login or register.

Notification

Error

Not Cooling refrig. or freezer Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: GSS25QGMCWW	Brand: GE	Age: 5 - 10 years
Previous Topic Next Topic

applrepairbiz		#1 Posted : Tuesday, November 12, 2013 8:51:09 PM(UTC)
Rank: Member Groups: Registered Joined: 11/12/2013(UTC) Posts: 2		Compressor not coming on; fan motors are on; lights on inside, and controls on front panel are lit. How can I test the start devices and compressor, so I can pin down which component is defective? I have a digital volt/ohm meter. Your help will be greatly appreciated. Denise


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

Appliance Ninja		#2 Posted : Wednesday, November 13, 2013 7:30:06 AM(UTC)
Rank: Member Groups: Registered Joined: 11/12/2013(UTC) Posts: 957		Hello, Denise! On the back of the refrigerator is a rectangular cover that is protecting the electronic control board. If you remove that, you will see a connector on three large spade terminals near the bottom of the board. One of those terminals is marked COMP. With the refrigerator running, measure the voltage between that terminal and the case of the refrigerator for 120 VAC. Do you read any voltage there?


User Profile View All Posts by User View Thanks

applrepairbiz		#3 Posted : Tuesday, December 3, 2013 12:50:10 PM(UTC)
Rank: Member Groups: Registered Joined: 11/12/2013(UTC) Posts: 2		Hi Appliance Ninja, thanks for your reply which I just found lost in my sea of emails. I had already bought and tried the overload / start relay assy. with no change, and assummed it was most likely the compressor, but I kept the frig. in hope it wasn't the compressor. (I did buy a small 10 cu.ft. frig. for the temporary). Anyway, I just opened up the back of frig. & removed the control bd. cover; found the connector, but the only marking on board was pin numbers J8, J9, J11. I read across all 3 spade pins (to frame ground). The two outside pins read 120 VAC (pins J8 & J11). What now?


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close