Rank: Member
Groups: Registered
Joined: 10/24/2012(UTC) Posts: 3
|
My Whirlpool Top loading washer will not fill. I had a similar problem a couple of years ago and replaced the inlet valve (8181694), so I replaced it again, since we have very hard water. Problem still exists. I have verified that water is coming out of both hot and cold hoses. The washer will go into spin cycle. Where do I go from here? :confused:
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
The model number you posted does not come up. Verify and repost it please.
Gene.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/24/2012(UTC) Posts: 3
|
The correct model number ends in LW0. Sorry for the confusion. The old eyes ain't what they used to be!:(
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
There is something wrong in the beginning of the model number too. Double check it please.
Gene.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/24/2012(UTC) Posts: 3
|
GSQ9633LW0 or GSQ9633LWO.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
The model number GSQ9633LW0 is the correct one. Good job! Most likely the problem is a bad ATC (water temperature) control board (inside the control panel) but there is a small chance for the temperature switch to be bad as well. I would replace the ATC board first. - The ATC board Part number: 3955728
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close