Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

207 Pages«<175176177178179>»
Options
Go to last post Go to first unread
ment2b  
#1761 Posted : Friday, September 21, 2012 1:05:04 PM(UTC)
ment2b

Rank: Member

Groups: Registered
Joined: 9/20/2012(UTC)
Posts: 9

Originally Posted by: Gene Go to Quoted Post
You are welcome. Hopefully the new heater will fix it. Thank you for the feed back.

Gene.


OK, success in attaching the photo. Here's the evaporator coils, when panel first removed :
ment2b attached the following image(s):
freezer.jpg
Gene  
#1762 Posted : Friday, September 21, 2012 1:11:52 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
Did you take this picture before or after repair?

Gene.
ment2b  
#1763 Posted : Friday, September 21, 2012 1:32:40 PM(UTC)
ment2b

Rank: Member

Groups: Registered
Joined: 9/20/2012(UTC)
Posts: 9

Originally Posted by: Gene Go to Quoted Post
Did you take this picture before or after repair?

Gene.


:D :D Very funny Gene!! Of course, before. From my previous post above :

Originally Posted by: ment2b Go to Quoted Post
Took over an hr with a hair dryer to get it all melted.


That's some bunch of frosty !
Philips  
#1764 Posted : Friday, September 21, 2012 3:33:29 PM(UTC)
Philips

Rank: Member

Groups: Registered
Joined: 9/21/2012(UTC)
Posts: 5

Originally Posted by: Gene Go to Quoted Post
By setting the freezer temperature control to the coldest position you almost closed the air flow from the freezer into the refrigerator. Using this control you actually operating with the air diffuser. Try to set the refrigerator temperature control to 4 and the freezer temperature control close to warmer position. Measure the temperature in both compartments 24 hours after you change the settings and post the results.

In regards of the problem with the drain from the freezer try to blow some air through the drain line after you defrosted it. Make sure the other end of the drain hose (on the back of the refrigerator) is clean as well.

Gene.

I have changed the settings and will post results tomorrow. What is the exact method of blowing air through the drain line? Is the drain hose on the back the vertical plastic tube?
Gene  
#1765 Posted : Friday, September 21, 2012 6:31:48 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
Originally Posted by: ment2b Go to Quoted Post
:D :D Very funny Gene!! Of course, before.

That's some bunch of frosty !


No wonder it did not work.

Gene.
Gene  
#1766 Posted : Friday, September 21, 2012 6:36:46 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
Originally Posted by: Philips Go to Quoted Post
...1. What is the exact method of blowing air through the drain line?...

...2. Is the drain hose on the back the vertical plastic tube?...


1. There are no such methods. Use your common sense.

2. Probably. It should come out of the refrigerator body.

Gene.
ghouseiv  
#1767 Posted : Saturday, September 22, 2012 6:09:43 AM(UTC)
ghouseiv

Rank: Member

Groups: Registered
Joined: 9/21/2012(UTC)
Posts: 1

Hi all,

I think I having the same problem as this thread:

Frigidaire Gallery: LGUI1849LF2
Less than a year old
Freezer on top, refrigerator on bottom

Perviously the freezer had frost everywhere and the refrigerator was really warm. So I thought I packed the freezer too much. I put all the food out and manually defrosted the unit for a day. I put all the food back in, turned the fridge back on and everything worked fine for a few weeks.
But recently frost has been building up on the back panel of the freezer again, and the ice cream is frozen solid. The refrigerator section seems ok for now though, but I think eventually I'm going to have the same problem as before.

I tried trouble shooting with the instructions on the first page:
Using a flat screwdriver, slowly turn the shaft in the middle of the defrost timer clock wise until it clicks to switch from the cooling cycle to the defrost cycle.

But looking at the diagram, how do I access the defrost control to test the defrost cycle? Do I have to remove any covering to access it?

Thanks in advance.
Gene  
#1768 Posted : Saturday, September 22, 2012 12:16:19 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
Is your refrigerator less than a year old?

If this is correct, don't do anything and call Frigidaire for service. Otherwise it can void the warranty.

Gene.
ment2b  
#1769 Posted : Monday, September 24, 2012 2:16:14 PM(UTC)
ment2b

Rank: Member

Groups: Registered
Joined: 9/20/2012(UTC)
Posts: 9

Originally Posted by: ment2b Go to Quoted Post
GE model GSS22KGPCWW. ~9 years old.
snipped

Gene, I'm picking up the replacement defrost heater tomorrow (fortunately I bought a lifetime warranty, when I replaced the heater 5 years ago)

There is now a 2 tube heater available for my model. In your experience, is this a better option vs the single tube ? I've now replaced the heater twice in 9 years.
Gene  
#1770 Posted : Monday, September 24, 2012 2:27:53 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
Yes, the double tube kit is much better. It provides better defrost for shorter time.

Gene.
Users browsing this topic
Guest (11)
Similar Topics
Freezer is fine, refrigerator is too warm. (Refrigerator & Freezer Repair)
by mrhoagie 11/3/2012 1:46:58 PM(UTC)
Another Freezer is fine, refrigerator is too warm. (Refrigerator & Freezer Repair)
by rzeune 10/7/2010 9:19:39 AM(UTC)
Freezer is fine, refrigerator is too warm. (Refrigerator & Freezer Repair)
by allemich 4/19/2009 8:02:07 PM(UTC)
207 Pages«<175176177178179>»
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.