Rank: Member
Groups: Registered
Joined: 9/6/2012(UTC) Posts: 2
|
Frigidare Model Lft7000eso. Original problem would not spin. cleaned pump trap, unit worked for about 2 months. Unit started not to spin again. Put unit in diagnostic mode and unit did spin. Got error code 48. Ordered lock assembly. I used wahser serveral times while waiting for lock. Unit wont do anything now Replaced lock assemby..no change . Unit powers on ,But when pressing start door does not lock and no functions Can not get it to go into diagnostic mode. checked all wiring connecdtors and wiring harness to lock assembly no problem found. Also checked voltage on control board. voltage is normal120Vac in12Volt out.
Any suggestions??? Thanks Mark
|
|
|
|
Rank: Advanced Member
Groups: APP Team
Joined: 2/12/2012(UTC) Posts: 5,556
|
Hi.
Based on your descriptions I suggest you to check the wire harness and connections. If that is OK - replace the control board.
If you need a part number check the model number again - it's not coming up.
Simon.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 9/6/2012(UTC) Posts: 2
|
Thanks Model number is LTF7000ESO sorry type error. I checked continuity on the harness to the lock assembly and all wires measure correctly.
|
|
|
|
Rank: Advanced Member
Groups: APP Team
Joined: 2/12/2012(UTC) Posts: 5,556
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close