AppliancePartsPros.com
»
Appliance Repair Help
»
Dishwasher Repair
»
Kenmore Ultra Wash Doesn't Drain Complete at End of Cycle
Rank: Member
Groups: Registered
Joined: 6/8/2012(UTC) Posts: 4
|
The washer has stopped draining completely at the end of a cycle. I've checked the check valve and confirmed it is clear. I've also confirmed solid discharge at the air gap. I'm not sure what direction to go with this. Timer problem? Broken/worn discharge impeller? If I pull the pump to check the impeller - do I need to replace a gasket? Thanks for any help.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Originally Posted by: Eric1974 ...I've checked the check valve and confirmed it is clear... Did you unscrew it from the pump? - The check valve Part number: 675238
Gene.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 6/8/2012(UTC) Posts: 4
|
Yes. I also flushed water through the valve and it appeared to be functioning correctly. I have also determined the washer drains completely twice during the wash cycle.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
How much water left in the dishwasher at the end of the cycle? Did you check it right after the cycle was done or sometime later?
Gene.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 6/8/2012(UTC) Posts: 4
|
I am checking it right away. There is probably a couple of inches of water.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 6/8/2012(UTC) Posts: 4
|
It just went through the entire rinse cycle without draining. The dry cycle starts with water over the coil.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Originally Posted by: Eric1974 It just went through the entire rinse cycle without draining. The dry cycle starts with water over the coil. Did it keep rinsing until it came to drying? If it did, replace control board. - The control board Part number: 8530929
gene.
|
|
|
|
AppliancePartsPros.com
»
Appliance Repair Help
»
Dishwasher Repair
»
Kenmore Ultra Wash Doesn't Drain Complete at End of Cycle
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close