Rank: Member
Groups: Registered
Joined: 5/3/2012(UTC) Posts: 2
|
Washer only works (drains & spins) in any spin cycle. It is dead in all the wash cycles. Replaced timer but that did not fix the problem. Replaced load sensor switch less than a year ago. Don't know where to go from here...???
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Does the motor run when it should agitate? Does it make any noise?
Gene.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 5/3/2012(UTC) Posts: 2
|
Originally Posted by: Gene Does the motor run when it should agitate? Does it make any noise?
Gene. Thanks for replying. The washer is totally dead in all wash cycles but works properly to drain and spin in all cycles. I ordered a new load sensor switch hoping that will fix the problem. At first I replaced the timer but the problem remained.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Check the washer speed switch (#28 at the diagram) according to the table from the attached tech sheet. - The speed switch Part number: W10180780
Gene.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close