I have a maytag neptune front load washer. The clothes were still wet after spinning so I selected just the spin cycle. The minute timer hits the 7 minute mark when I am assuming the the spin cycle should start, then it jumps to 0 and stops.

There are no error codes that display and the door lock is engaged. I have looked at other forums an found someone made a suggestion that it is the balance load switch is corroded. I have yet to take the front of the machine apart to see, but does this sound like a plausible solution?

I have checked the internal drain lines they are clean, and have recently replaced the water pump, so those aren't it. I was thinking that it was the control board, but from reading a lot of posts from people they were having other issues that I am not experiencing.