Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
Hexster  
#1 Posted : Saturday, August 27, 2011 5:12:56 PM(UTC)
Hexster

Rank: Member

Groups: Registered
Joined: 2/26/2011(UTC)
Posts: 8

I just got a used roper top load washing machine about 5 yrs old or more. The tub seems to sag to one side. I checked the springs and they are all there. The machine washes fine but spins violently in the spin cycle. I am pretty handy but am not an appliance pro. Why is it spinning out of control? How do I fix it? Any help is appreciated. thanks.

Hexster (A hands-on learner)
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
richappy  
#2 Posted : Sunday, August 28, 2011 3:05:20 AM(UTC)
richappy

Rank: Advanced Member

Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586

Was thanked: 2 time(s) in 2 post(s)
Remove the outer cover and inspect the skate plate under the tub, look for misalignment from the move. Just move the tub up and down to position it right.
Hexster  
#3 Posted : Sunday, August 28, 2011 5:47:02 AM(UTC)
Hexster

Rank: Member

Groups: Registered
Joined: 2/26/2011(UTC)
Posts: 8

Thanks, Richappy.
I tried that and it stays put until I run the spin cycle. Then it shakes uncontrollably. From the top I can move it around and it seems to "click" in to place but that technique goes out the window when running. Other than the springs, is there anything else holding it centered/upright? Any other suggestions?

Thanks.
Hexster
richappy  
#4 Posted : Sunday, August 28, 2011 6:41:27 AM(UTC)
richappy

Rank: Advanced Member

Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586

Was thanked: 2 time(s) in 2 post(s)
You might be missing the brown,plastic slides on top of the skateboard, should be 3 of them.
Look at the front of the washer, if the tub is tilting one way, your skateboard is still not sitting right.
Hexster  
#5 Posted : Monday, August 29, 2011 7:27:53 PM(UTC)
Hexster

Rank: Member

Groups: Registered
Joined: 2/26/2011(UTC)
Posts: 8

Yes, one of those skid plates were missing. Thanks. I have one quick question... Is the skate plate supposed to be attached to something or is it supposed to be loose and wedged into place? thanks again.
richappy  
#6 Posted : Tuesday, August 30, 2011 1:05:25 AM(UTC)
richappy

Rank: Advanced Member

Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586

Was thanked: 2 time(s) in 2 post(s)
Supposed to be loose.
Users browsing this topic
Guest (6)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.