Rank: Member
Groups: Registered
Joined: 12/19/2008(UTC)
Posts: 2
|
First off all the top burners and broiler are fine. The oven burner takes a long time to light and will not stay lit, but will go out and then relight for a few seconds then go out again. Takes very long time to get up to tempture setting, some times never. Any ideas of the cause, igniter, the short or control panel?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 8/13/2008(UTC)
Posts: 3,097
|
If you have an ohm meter, test the ignitors. If they ohm out (3 to 3.5 ohms) the the problem is your valve.
Here's the breakdown CGR3520BDH
AP4098213 - valve
Nat
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/19/2008(UTC)
Posts: 2
|
Not to sure I did it correctl, but the ohm were below 3
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 8/13/2008(UTC)
Posts: 3,097
|
I think if you replace the ignitor you should be good to go.
Nat
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
