Rank: Member
Groups: Registered
Joined: 12/12/2008(UTC) Posts: 1
|
I have replaced the relay components (2) overload and relay, and cannot remember ifr the 2 black wires from the capacitor connect to both the overload switch and the relay, or if they connect to opposite sides of the relay and the red wire connects to the overload component. could you instruct me or show me a schematic so i don't mis-wire this? thanks - Tim
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 8/13/2008(UTC) Posts: 3,097
|
Your schematic should be in your unit, probably in a plastic pouch near the compressor.
Nat
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC) Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
If you replaced the thermal overload to the right pin, the capacitor gets wired across the two remaining pins.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close