Rank: Member
Groups: Registered
Joined: 10/21/2008(UTC)
Posts: 3
|
Microwave is not a DACOR...it is a DANBY that was not in the list.
Whenever the door is shut the microwave is up and running. Works great other than the fact that the only way to shut it off is to open the door.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 10/9/2008(UTC)
Posts: 784
|
It has a bad interlock switch in interlock module its were the door latches and trips the switches usually there are three of them a primary a secondary and a monitor switch
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/21/2008(UTC)
Posts: 3
|
I figured it out!!! On the main circuit board[GAL9823] there are 2 "black boxes"(Galanzjd2-1A 12vdc 16A 12v....) when you remove the wires from either of the boxes and use a tester to test for continuity there should be nothing. Both of them showed continuity. I took another circuit board out of another Danby microwave(that I found in the dump....that one only numbers 1-3 would work on the touch pad) I swapped the circuit boards and it works great!!!!
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 10/9/2008(UTC)
Posts: 784
|
good for you ,,,,what luck huh?
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/21/2008(UTC)
Posts: 3
|
mighty...doesnt usually work that way....
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
