Maytag LAT9206BAE Options  Email this topic  Watch this topic  Print this topic » Normal Threaded
Model: LAT9206BAE	Brand: Maytag	Age: 5 - 10 years
Previous Topic Next Topic

454		#1 Posted : Tuesday, October 14, 2008 5:18:04 AM(UTC)
Rank: Member Groups: Registered Joined: 10/13/2008(UTC) Posts: 5		Washer will not spin and there is a burning smell, works fine up until that point
User Profile View All Posts by User View Thanks

Sponsor
	See inside of your appliance - diagrams and part photos for virtually every model. By Model Number By Part Description By Part Number powered by AppliancePartsPros.com

libertyappl		#2 Posted : Tuesday, October 14, 2008 6:35:05 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 8/13/2008(UTC) Posts: 3,097		Check your belts & pulleys to see if one of the "locked" up. nat
User Profile View All Posts by User View Thanks

454		#3 Posted : Tuesday, October 14, 2008 7:07:13 AM(UTC)
Rank: Member Groups: Registered Joined: 10/13/2008(UTC) Posts: 5		Checked both pullys and they turn freely. Is there anything else I can check?
User Profile View All Posts by User View Thanks

454		#4 Posted : Tuesday, October 14, 2008 7:10:36 AM(UTC)
Rank: Member Groups: Registered Joined: 10/13/2008(UTC) Posts: 5		It finishes the cycle before spin and it tries to go into spin but it doesn't
User Profile View All Posts by User View Thanks

libertyappl		#5 Posted : Tuesday, October 14, 2008 8:03:04 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 8/13/2008(UTC) Posts: 3,097		Test your motor & motor switch. Here's the breakdown of you machine. Model LAT9206BAE Nat
User Profile View All Posts by User View Thanks

454		#6 Posted : Tuesday, October 14, 2008 8:13:09 AM(UTC)
Rank: Member Groups: Registered Joined: 10/13/2008(UTC) Posts: 5		How do I test the motor and the switch?
User Profile View All Posts by User View Thanks

v2k04		#7 Posted : Tuesday, October 14, 2008 8:34:54 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 10/9/2008(UTC) Posts: 784		here is how you hotwire a Maytag motor but you could have a siezed up spin bearing causing your problem as well pull the front cover and look at center of tub underneath and see if water is leaking which took out the bearing if it has your probably looking at a new machine attached is the diagram v2k04 attached the following image(s):
User Profile View All Posts by User View Thanks

454		#8 Posted : Friday, October 17, 2008 8:37:20 AM(UTC)
Rank: Member Groups: Registered Joined: 10/13/2008(UTC) Posts: 5		It ended up being the siezed bearing, water had leaked down on it. Thanks for the help
User Profile View All Posts by User View Thanks

SPRINT		#9 Posted : Tuesday, January 4, 2011 12:26:40 PM(UTC)
Rank: Member Groups: Registered Joined: 1/4/2011(UTC) Posts: 1		Could we get a little bigger, readable wire diagrahm on this one Thanks.
User Profile View All Posts by User View Thanks

Users browsing this topic

Guest (6)