NE one? troubleshooting or a schematic? thanks

The ERC[?] (double, piggy-backed board) is out and I cannot see any burned components or cold solder joints, though some look better than others. The pins and ribbon look okay, too.

Resistance of the upper oven overtemp is about .2 wired in and .3 with a pin removed. I doubt, however, thhat eve if faulty, it would keep the entire display dark; no activity, light or error code.

I have not pulled the relay circuit boards (2) yet, but they look good from 14".

I am wondering if there is a secret to getting a reply to my post, outside my own.

I just got a list of places from JennAir, that might have a manual. I am about to call around.

Up until now, I am limited to obvious issues. They said thay have a company that does C/B testing and repair; not sure if these boards are even available, otherwise.

Thanks for the reply.

Answered here: http://forum.appliancepartspros...n-oven-3.html#post260451

Gene.

So, what do you think off changing the relay board first, as that is the only one they sent?

Despite being charged for both pricey boards, only one was sent with no notice of the other being back ordered, until the box arrived and no expected ship date. Not good customer service.