Rank: Member
Groups: Registered
Joined: 3/31/2008(UTC)
Posts: 2
|
I have a General Electric gas oven JGBP35, the oven does not get up to the proper heat. I changed the Tempature sensor and it still doesn't work. The oven egnitor works the burner goes on for 10-20 seconds and then turns off, about 3-4 minutes later it goes back on for 10-20 seconds. Any ideas?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Most likely the problem is a bad oven control. In order to provide the right part number I need the rest of the model number.
Gene.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/1/2008(UTC)
Posts: 2
|
I have same problem but nobody want to help me and i have the exact model nr.I think the don`t know.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/31/2008(UTC)
Posts: 2
|
Originally Posted by: Gene  Most likely the problem is a bad oven control. In order to provide the right part number I need the rest of the model number.
Gene. Hi Gene, Thanks for responding. The entire model number is JGBP35GEP3WG
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Hi onenwalsh, The part number for the control board (without overlay) is AP2632694 The overlay is no longer available. You have to be careful not to damage it when you'll remove it from the old control board. It is selfadhesive. Gene.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
