Rank: Member
Groups: Registered
Joined: 3/14/2008(UTC)
Posts: 2
|
Kenmore dryers will not stay started. Only holding down the start button will allow it to continue. It also does not seem to be heating.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 3/11/2008(UTC)
Posts: 66
|
Odds are you have a bad even heat control.
If your dryer says "Even heat" or "Soft heat" somewhere on the console, you have a bad even heat control. The even heat control not only controls the heat, but it also engages the motor relay. That is why you have to hold the start button.
Matt
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/14/2008(UTC)
Posts: 2
|
Is the "even heat controller" easy to remove and replace by a fair handyman?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 3/11/2008(UTC)
Posts: 66
|
Yup, it is a circuit board under the console. Remove the two philips screws at the front bottom of the console. The console flips up and the board is in the center behind the console.
When you order the even heat control, you may get a small harness and relay with the kit. Follow the instructions. It is not hard to do if you are familiar with simple hand tools. :)
Matt
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Hi jbcholding,
In addition to Matt, if you would like the right part number for the control board we need the complete model number of the dryer.
Gene.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
