Rank: Member
Groups: Registered
Joined: 10/28/2009(UTC)
Posts: 2
|
The unit is a BUCK Stove propane vent free...it works fine but recently, the pilot light grew from about a quarter of an inch to around a full inch or more...Looking at the unit, it isn't obvious how or what to replace...
Any info would help...
Thank you
1
Nick
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 5/6/2008(UTC)
Posts: 724
Was thanked: 1 time(s) in 1 post(s)
|
ODS (oxygen depletion system) gas safety heaters/fireplaces. Notice the hole to clean arrows. You can use a straw to blow out the dust or shop air also. When the dust is removed the heater will work properly
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/28/2009(UTC)
Posts: 2
|
Thank you for the reply!! It isn't the hole though...the hole is completely clear...I blew it out thoroughly. The design I have has a thin metal piece covering one side of the hole. If I lift it off, the flame intensifies...
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 5/6/2008(UTC)
Posts: 724
Was thanked: 1 time(s) in 1 post(s)
|
get some rust buster and flush the pilot
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
