Rank: Member
Groups: Registered
Joined: 10/16/2009(UTC)
Posts: 2
|
I have an Asko 1585 dishwasher that i was changing the front panel (cracked)
I must have grounded something because the circuit board attached to it flashed, popped then smoked (yes, i did not turn off the breaker - doh!)
Is the circuit board now no good because when i put it all together again there's no lights.
Thanks
Playit_47
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638
Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
|
Since the board arced and smoked you can probably find the component that failed on the board.
The problem is that appliance manufacturer's do not publish board schematics so the board will have to be replaced.
It may make more sense to get a new dishwasher depending on the board cost. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/16/2009(UTC)
Posts: 2
|
i kind of came to that conclusion when the kids went "cool dad, do that again!" lol. But thanks for confirming that it's toasted.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
