Rank: Member
Groups: Registered
Joined: 7/25/2009(UTC)
Posts: 3
|
The control assembly (part no. [FONT='Calibri','sans-serif']WH12X10169)[/FONT] had to be replaced but now that it's installed the washer is in diagnostic mode and all the LCD lights are blinking. When the old part is put back in, the washer works in operating mode. How do I fix this?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
Look in the service sheet behind the control panel for exiting the diagnostic mode.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/25/2009(UTC)
Posts: 3
|
Originally Posted by: richappy  Look in the service sheet behind the control panel for exiting the diagnostic mode. We did that. Didn't work. Do you think the part is defective?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
Check the paperwork with the part, or call the supplier, they may have some info on this.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/25/2009(UTC)
Posts: 3
|
I found the answer to this question.
On the old one is a connector with jumper wires that adapt the control to different models . You must install this part on the new control.
I got this answer from Justanswer.com. I got it in less than 5 minutes.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
