Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
I have replaced the control board and control panel board,(they come as a set) twice in the last six months.
Now, when I select any wash button then push the start button, the wash button blinks and nothing happens. I can push #4 & #8 buttons at the same time and sometimes it will go into diagnostic mode with lights flashing, but still cannot do any diagnostic tests, no buttons work.
Eventually, all the lights will go out and I can try it again with same results.
Hope someone has seen this before.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
I think I found the problem. The whole panel flexes when I close the door and I think it is damaging the keypad.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
