Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error
pulling error codes
Options
Go to last post Go to first unread
Model: LTF2140ES Brand: Frigidaire Age: 1 - 5 years
Previous Topic Next Topic
pdq_wizzard  
#1 Posted : Monday, February 22, 2010 8:34:04 AM(UTC)
pdq_wizzard

Rank: Member

Groups: Registered
Joined: 2/22/2010(UTC)
Posts: 3
OK my washer will not do the final spin everything else seems to work fine, I have timed the drain / spin cycle and it is:
4 min from start to finish, 3min and 10 sec of that the drain pump is running then it does a back and forth slow tumble (like when it is washing) for about 50sec.
When I pull the codes I press the start and the pause/cancel buttons at the same time after about 3 sec there is 4 beeps and the five lights on the right light up at the same time it beeps. Then the start light blinks 3 times with no beep sounds.

Is this a code 43 and am I doing it right? The Error code chart says that a E43 is a Control board problem, and to replace it. Is there any other tests I should run before putting out $$ for a new CB?

Thanks!
pdq_wizzard attached the following image(s):
IMG_0257.jpg
Back to top
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com 		 
Back to top  
pdq_wizzard  
#2 Posted : Tuesday, February 23, 2010 7:25:53 AM(UTC)
pdq_wizzard

Rank: Member

Groups: Registered
Joined: 2/22/2010(UTC)
Posts: 3
OK I found a PDF on this website that gave me most of the information I needed, I did all the test cycles and they all work but I still get a E43 error. last night when I was messing around I had a load go all the way through including a final spin ??? but today it didn't do the final spin.
is it normal for a bad CB to work sometimes and not others?
Back to top
pdq_wizzard  
#3 Posted : Thursday, February 25, 2010 7:09:58 PM(UTC)
pdq_wizzard

Rank: Member

Groups: Registered
Joined: 2/22/2010(UTC)
Posts: 3
anyone know if a new board will fix my problem?
Back to top
Users browsing this topic
Guest (2)
Similar Topics
Trouble pulling error codes (Dryer Repair)
by dhm 4/18/2016 6:14:50 PM(UTC)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Privacy Policy | Powered by YAF.NET | YAF.NET © 2003-2025, Yet Another Forum.NET