Rank: Member
Groups: Registered
Joined: 4/2/2009(UTC)
Posts: 7
|
I have frontload washer make loud noise when It spin. I just replaced new vibration shock absorber but not making better. Thanks in advance
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 3/29/2009(UTC)
Posts: 11,699
|
This is very common with this model. It is likely the rear bearing is failing. You can listen to it and if the sound comes from the rear, that is what it is.
Unfortunately, it is not a repairable item, you have to replace the back half that contains the bearing. Since it is an expensive repair I would advise running the machine until you can no longer stand the noise, then getting a new one.
Sorry not to have better news.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/2/2009(UTC)
Posts: 7
|
thanks fot your help. today I just disassembly outer tub and there is the shaft attached to the spider ( 3 wings ) likely 3 arms bolted to inner tub. and 3 arms were broken off , so the shaft is not holding the inner tub. actualy I look in part ( diagram number 4 ( wshr tub, motor) the part AP2107258 is $243.56 + shipping , I dont know what should I do right now . thanks again
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
You probably also have bad tub bearings, makes the repair too expensive.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
