AppliancePartsPros.com
»
Appliance Repair Help
»
Washer Repair
»
Front load washer will not rinse/drain or spin out
Rank: Member
Groups: Registered
Joined: 12/9/2009(UTC) Posts: 3
|
My washer justs stops after wash cycle. Have to change the control knob to rinse and spin. Then change it again to spin and drain. Error code comes up as E23;Replace control board. Did that but still does the same thing. What is wrong?:eek:
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 3/29/2009(UTC) Posts: 11,699
|
I would do the following before ordering any more parts. 1. Clean out the drain pump and the drain hoses. 2. Check all of the wiring between the control board, pump, door lock assembly and motor control board. You are looking for a short, or bad insulation or some other problem. Here is a service manual for your machine which is a Frigidaire. You may have to try replacing the speed control board but that would be on speculation, so try to check the easy stuff first. http://frigidaireservicetips.co...rizontalAxisWasherSM.pdf
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/9/2009(UTC) Posts: 3
|
Thanks.Will look into those.
|
|
|
|
AppliancePartsPros.com
»
Appliance Repair Help
»
Washer Repair
»
Front load washer will not rinse/drain or spin out
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close