Rank: Member
Groups: Registered
Joined: 6/10/2024(UTC) Posts: 0 Location: California
|
The microwave light bulb on this 20+ years old Whirlpool Oven/Microwave wall-mounted combo ModelGMC305PDB2 has failed. I need to figure out how to pull out the microwave to replace the light bulb on top. I had seen a video some 10 years ago but can't find it any longer. EDIT: Found a fairly close video here and accessed the light bulb. The circuit indicates it is the only item using the 12V output of a dedicated transformer. Steps: 1- Remove two screws holding each of the side trims. Pry the trim out by sliding it down. 2- Remove the two side screws to disengage the interface panel. 3- Remove the microwave vent grill. 4- Remove the oven vent grill. 5- Remove two screws holding the microwave in place. Pull the microwave about 1/2 way out. 6- Remove the spring clip holding the lamp assembly. 7- Replace the halogen lamp without touching its surface with bare hands. 8- Follow the steps in reverse to put everything back together. Edited by user Monday, June 10, 2024 6:14:12 PM(UTC)
| Reason: Solved update
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 5/12/2024(UTC) Posts: 0 Location: Ontario Was thanked: 10 time(s) in 10 post(s)
|
Hi,
That should help others....thankx!
jeff sr. |
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close