Rank: Member
Groups: Registered
Joined: 2/16/2024(UTC)
Posts: 0
|
GFW650SSN0WW
Problem starts as machine would stop once it reached the high spin at end of cycle.
I replaced the door lock switch mechanism.
Problem remains.
Error codes yield: codes 18 (drain pump), 27 (water access), 38, 89 (accellerometer fault), and 91.
I ran the tests for each one and everything seemed to work fine (i.e., water filled, drains, tub spun at high, etc.).
Ran full run, stopped at spin cycle again. Error codes remain.
Any ideas/suggestions?
Thanks
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 2/16/2024(UTC)
Posts: 0
|
...just ran another cycle. it stopped part way thru. then restarted it, and now just completed the full spin cycle. seems very erratic.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 2/16/2024(UTC)
Posts: 0
|
Individual cycles ran in test mode seem to work.
But in full run most always stopppng at the spin cycle
I suspect control board ineeds replacing. Any final tests recommended to verify control board as issue?
Thanks
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/4/2022(UTC) Posts: 0  Was thanked: 1 time(s) in 1 post(s)
|
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
