My old GE electric range (Model JBP81T0M2WW) has control board WB27T10864. Every reference I have found for this board says it has been replaced by control board WB27T11276 so that's what I ordered. When I went to install it, I carefully numbered all the wires and took a picture of both the old and new control boards. When I closely examined the new board I discovered there is one less connector which leaves an extra wire that I have no idea where to connect it.

Any suggestions?

Edited by user Sunday, September 5, 2021 11:30:57 AM(UTC)  | Reason: Photos attached did not display