Neptune Wont Drain - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! You can not login or register.

Notification

Error

Neptune Wont Drain Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: MAH9700AWW	Brand: Maytag	Age: 5 - 10 years
Previous Topic Next Topic

dstrakele		#1 Posted : Saturday, January 23, 2016 11:35:24 AM(UTC)
Rank: Member Groups: Registered Joined: 1/23/2016(UTC) Posts: 2		I checked the pump and it spins freely. ( strong magnets but not jammed) Connected the pump to 110 on the bench and it runs fine water drained when the pump was removed. Service mode, board output test, quick wash, pump does not spin. 42 volts at pump connector (?) 120 volts from pin 1 of CN5 to pin 6 of CN 10 ( all the time with DVM) Pin 6 of CN10 to pump connector is 0 ohms Pin 1 of CN 5 to pump connector is 0.6 Meg ohms. Seems like something has a high resistance between what I assume is netural and the pump. Pin 6 of CN 10 also reads 110 to ground so I figure that is hot? I dont want to buy a control board if that EMI filter or something else is the issue. Any thoughts? Dave


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

sidfink43		#2 Posted : Saturday, January 23, 2016 1:09:26 PM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 3/29/2009(UTC) Posts: 11,699		Great job of diagnosing! Since you have determined that the pump runs when 110v is applied and that there is not blockage this probably means that the control board is not sending power to the pump when it should. Go ahead and replace the board, and if you buy from this site and the new board does not fix the problem you can return it. Be sure and check all the wiring first, but I imagine you have already done that.


User Profile View All Posts by User View Thanks

dstrakele		#3 Posted : Saturday, January 23, 2016 2:50:19 PM(UTC)
Rank: Member Groups: Registered Joined: 1/23/2016(UTC) Posts: 2		Thanks for the quick response! I will order the board right away. Thanks Again. Dave


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (4)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close