Rank: Member
Groups: Registered
Joined: 9/6/2015(UTC) Posts: 1
|
I have a 5 year old GE Cafe dishwasher that will not fill with water. Water inlet valve has been replaced. Float valve seems operational. If I manually add water to the tub and start the machine, it runs through the cycle but will not refill and water does not seem to be jetting out of the arms. Appreciate any suggestions.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
Here are your parts Parts for GE CDWT980R10SS Dishwasher - AppliancePartsPros.comCheck across the water valve when it should be filling. If you have 120 volts and it is not filling you have a bad valve. If there is not 120 volts, check across the overfill switch. If you have 120 volts then the switch is either not activated or it is bad. If no voltage there either, remove power from the machine and check the wires using resistance from the control board down to the valve/switch combo. If OK, then odds are that the control board is bad. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close