All LEDs out, only the start switch works - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

All LEDs out, only the start switch works Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: GU940SCGT3	Brand: Whirlpool	Age: More than 10 years
Previous Topic Next Topic

Jimbo Bigbelly		#1 Posted : Wednesday, February 11, 2015 11:55:12 AM(UTC)
Rank: Member Groups: Registered Joined: 2/8/2015(UTC) Posts: 8		I have this dishwasher, it looks fairly well-kept. Washes well, but only the start switch works, the rest don't. There is a delay switch, several wash cycle switches, a cancel and drain switch, etc. There are several LEDs on the front control panel, and none of them work. And the switches that would cause them to lite up don't work as well. I reseated the ribbon cable connector to the controller board, same symptom. The controller board costs $225 at AppliancePartsPros.com, so I'm hoping for a common problem, maybe an open ground? It could be the flex circuit, but an open ground is the only thing that could cause all the switches to stop working. The Normal Wash switch works. The LED behind it does not. Any ideas would be great. Thanks!


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

chuckiejones		#2 Posted : Monday, February 23, 2015 7:09:20 PM(UTC)
Rank: Member Groups: Registered Joined: 3/15/2011(UTC) Posts: 6		I have a KitchenAid dishwasher KUDL03iTSS. It got a little flaky then quit. Last known flakyness was dryer LED was indicated but unit had not drained. Now, no LEDs are lit. Has power to unit. Checked at two places.


User Profile View All Posts by User View Thanks

chuckiejones		#3 Posted : Monday, February 23, 2015 7:39:02 PM(UTC)
Rank: Member Groups: Registered Joined: 3/15/2011(UTC) Posts: 6		Originally Posted by: chuckiejones I have a KitchenAid dishwasher KUDL03iTSS. It got a little flaky then quit. Last known flakyness was dryer LED was indicated but unit had not drained. Now, no LEDs are lit. Has power to unit. Checked at two places. I reset the 14 pin connector a couple of times. Still no LEDs. I pushed start and the system appears to be working normally. Hope this can help others.


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (2)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close