Rank: Member
Groups: Registered
Joined: 8/4/2009(UTC)
Posts: 7
|
Gene,
Installed new erc and everything is fine. Looks like it was both the faulty erc and the cracked keypad.Original sercvice guy was going to order the relay board, glad I did it myself, thanks for your help.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
You are welcome. Glad to hear it. Thank you for the feedback and good luck with your oven.
Gene.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/24/2009(UTC)
Posts: 6
|
The clock displays OK. If I press any oven mode, Bake, Convection, etc. then I set the temp, I hear clicking and the display says pre-bake on with bake flashing, but then the oven turns off after about 10 seconds.
Model - AOCS3040WW
MFG - P1132348NWW
This sounds similar to the problem above but I'd like some advice from the expert.
Thanks.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/4/2009(UTC)
Posts: 7
|
If you turn off power supply (at breaker) and the power back up do you get any error codes....may have to wait a few minutes before code comes up.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/24/2009(UTC)
Posts: 6
|
The oven over the years has occasionally got the F1 code but it comes and goes. During this last problem, it got an F1 briefly.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Originally Posted by: tommagner  The oven over the years has occasionally got the F1 code but it comes and goes. During this last problem, it got an F1 briefly. Most likely the problem is a bad Electronic Range Control. - The ERC Part number: AP4040447
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/24/2009(UTC)
Posts: 6
|
Thanks very, I'll order one and give it a try....Tom
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/29/2009(UTC)
Posts: 2
|
Originally Posted by: tommagner Thanks very, I'll order one and give it a try....Tom I've got the exact same problem so would like to know how you make out. Mine has been doing this on and off for about 4 years but only during the summer, only shuts off while it's hot and I can usually get it going again after about 5 minutes of trying.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/24/2009(UTC)
Posts: 6
|
My ECR will be delivered tomorrw, I'll post to let you know how it works. I won't get to it until after 6:00 PM EST but if all goes well and it's not too late I'll post the result...Tom
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/24/2009(UTC)
Posts: 6
|
I installed the new ECR today and the oven works great. 8 screws and 3 wire connectors is all it takes. Thanks for all the help, great diagnostic job....Tom
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
