Roper washing machine agitates but won't spin out. - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

Roper washing machine agitates but won't spin out. Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: RTW4100WQ1	Brand: Roper	Age: 1 - 5 years
Previous Topic Next Topic

Ktlyn129		#1 Posted : Sunday, July 20, 2014 4:13:09 PM(UTC)
Rank: Member Groups: Registered Joined: 7/20/2014(UTC) Posts: 1		It seems like it is going to be a simple repair but not quite sure what the exact problem is. The machine washes and rinses the load fine but when it is supposed to spin out the water it just drains without the spin. Any ideas?


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

sidfink43		#2 Posted : Monday, July 21, 2014 6:00:57 PM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 3/29/2009(UTC) Posts: 11,699		Normally this is a clutch problem. Here is the part and there is a video that will show you how to change it out. It is not a difficult task but it helps to have a helper and it will take some time. Whirlpool 285790 Clutch Band and Lining Kit - AppliancePartsPros.com


User Profile View All Posts by User View Thanks

hvac54		#3 Posted : Monday, July 21, 2014 7:02:43 PM(UTC)
Rank: Member Groups: Registered Joined: 10/1/2010(UTC) Posts: 5		you could have a bad lid switch also. Lid switch lot cheaper and easier and faster repair.


User Profile View All Posts by User View Thanks

fairbank56		#4 Posted : Tuesday, July 22, 2014 4:34:31 AM(UTC)
Rank: Advanced Member Groups: Expert Joined: 10/16/2012(UTC) Posts: 3,806 Was thanked: 7 time(s) in 7 post(s)		It's not the lid switch. On this model, if the lid switch is bad, it won't agitate, drain or spin. Monitor the washer at end of agitation cycle. After agitation stops, the washer should drain for 2 minutes without spinning. The motor should then stop for a few seconds and start again. At that point, it should start spinning while continuing to drain. If there is no pause of the motor, the timer is bad, otherwise, the problem may be the clutch. You would need to remove the cabinet and bypass the lid switch so you can observe the clutch hub while in spin mode. Eric


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (4)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close