Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
bblouse  
#1 Posted : Tuesday, December 31, 2013 3:44:45 AM(UTC)
bblouse

Rank: Member

Groups: Registered
Joined: 12/30/2013(UTC)
Posts: 2

Whirlpool Gold Series side by side coils in freezer Ice up, refrigerator gets warm. Replaced bi-metal thermostat and heater and thermistor and fan test good. Is there anyway to test the pins Voltage on the UI control board for a faulty defrost timer? And or, anyway to test voltage on the main control board to determine which board is bad? Is there be anything else that can be tested?
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
denman  
#2 Posted : Thursday, January 2, 2014 4:06:48 AM(UTC)
denman

Rank: Advanced Member

Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638

Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
Here are your parts
Parts for Whirlpool GS6NBEXRB02 Refrigerator - AppliancePartsPros.com

See the attachment for the tech sheet.

Did you check any of the parts that you replaced with a meter before replacing them

Try forcing a defrost see the tech sheet.
Note that the defrost thermostat must be frozen for the defrost heater to come on. If the heater comes on then the main control board needs replacing as it is not programming a defrost cycle. Be careful that you do not burn your fingers.

If the defrost heater does not come on. Unplug the unit and check between P1-3 and P1-2 at the control board. It should be about 20 ohms (heater resistance). If this is OK then I would replace the main control board.
File Attachment(s):
GS6NBE.pdf (1,320kb) downloaded 37 time(s).
THIS FORUM IS DEAD!!!!!!!
Users browsing this topic
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.