Rank: Member
Groups: Registered
Joined: 9/20/2013(UTC) Posts: 2
|
Top works and control board works. Both elements will not turn on to either a bake or broil command. Elements look good. Was thinking sensor, but didn't want to buy one before checking here.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
Here are your parts Parts for Maytag MES5775BAB Range - AppliancePartsPros.comSee the attachment for the tech sheet. If the unit shows that the oven is ready then it could be the oven sensor. It should measure about 1,100 ohms at room temperature. If the oven stays in pre-heat then the hi-limit thermostat (item 6 in the Body Parts section) may be open. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Rank: Member
Groups: Registered
Joined: 9/20/2013(UTC) Posts: 2
|
Thank you for your response. Where is the thermostat located. I see it in a separate box on that schematic. Wondering how to access that.
Ohms are correct on the sensor. So that is most likely the culprit. Oven wouldn't move off of 100 before either.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
Looks like it is on the top right hand side of the oven compartment Hi-Limit Thermostat 1. Remove maintop assembly, see "Maintop Assembly" procedure. 2. Remove screws securing hi-limit thermostat to oven chassis. 3. Reverse procedure to reinstall hi-limit thermostat.
Maintop Assembly 1. Remove power from unit. 2. Remove range from installation position, see “Removing and Replacing Range” procedure. 3. Remove coil elements from installation position (select models). 4. Open oven door and remove screws securing maintop to oven chassis, located on the bottom of control panel and along the outside edges of the maintop. 5. Label and disconnect wiring to ribbon elements (select models). 6. Gently remove ceran top (select models) and place in safe area to prevent damage to top. 7. Remove porcelain maintop (select models). 8. Reverse procedure to reinstall maintop assembly. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close