Rank: Member
Groups: Registered
Joined: 6/19/2013(UTC) Posts: 1
|
My bottom element will not work had it tested and it is working getting code F10. Not sure what else to do.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
Here are your parts Parts for Frigidaire CFEF355FCB Range - AppliancePartsPros.comHere is a tech sheet. I could not find a sheet for a FCB unit so this tech sheet is for a FBC unit. It should be a close match if not exactly the same as your unit. http://manuals.frigidaire.com/p...ingfield/316458404en.pdfHave you tried removing power/unplugging the unit for a couple minutes to see if it will reset? F10 is an overheat error so check the oven sensor. Below is a good link, check out 7, 8, 20 and 21. http://www.applianceaid.com/electric-range-repair-topics.phpIf it will not reset and the sensor is OK then check the sensor connection on the control board. Check that the connectors are clean and properly crimped. Check for a cold solder joint, they are usually a duller silver and/or have pin holes. While looking at the solder side of the board gently wiggle the connector to see if it's legs move in the solder. A magnifying glass helps here. If all OK then odds are that the control board is toast. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close