GE washer won't agitate or spin- no error codes - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

GE washer won't agitate or spin- no error codes Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: WPRE6100G1WT	Brand: GE	Age: 1 - 5 years
Previous Topic Next Topic

Mark Falcon		#1 Posted : Monday, May 13, 2013 6:12:26 PM(UTC)
Rank: Member Groups: Registered Joined: 5/13/2013(UTC) Posts: 3		My 2 year old GE washer will not spin or agitate. I checked the motor- no error codes. I checked the control panel diagnostics- no error codes. Door switch checks out. Shifter coil resistance is around 95 ohms. Ran the manual mode diagnostics- no errors and all functions respond except low and high agitation and spin. LED on motor blinks continuously at 1 second intervals in ready mode. It is as if the circuit board relay is not delivering a start signal to the motor. I do not have schematics to trouble shoot further. Any input on how to determine if the motor is getting the start signal from the control?:confused:


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

fairbank56		#2 Posted : Monday, May 13, 2013 6:40:55 PM(UTC)
Rank: Advanced Member Groups: Expert Joined: 10/16/2012(UTC) Posts: 3,806 Was thanked: 7 time(s) in 7 post(s)		Place the washer in field service spin test. At the rightmost connector on the inverter, place one meter probe at the violet wire contact and then check with the other probe at black, yellow, blue and red. You should read 9 volts DC on each of those. If the readings are good, the motor/inverter is faulty. Eric


User Profile View All Posts by User View Thanks

Mark Falcon		#3 Posted : Monday, May 13, 2013 7:48:50 PM(UTC)
Rank: Member Groups: Registered Joined: 5/13/2013(UTC) Posts: 3		Eric, Voltage measures 9 VDC between the violet and the black, blue, yellow and red leads. Is it time to replace the motor? Thanks, Marks


User Profile View All Posts by User View Thanks

fairbank56		#4 Posted : Tuesday, May 14, 2013 4:41:17 AM(UTC)
Rank: Advanced Member Groups: Expert Joined: 10/16/2012(UTC) Posts: 3,806 Was thanked: 7 time(s) in 7 post(s)		Yep, sounds like it, assuming the lid switch is good and the belt. Eric


User Profile View All Posts by User View Thanks

Mark Falcon		#5 Posted : Tuesday, May 14, 2013 5:00:22 AM(UTC)
Rank: Member Groups: Registered Joined: 5/13/2013(UTC) Posts: 3		Thank you for your help Eric! I will try replacing the motor. Mark


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (2)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close