Rank: Member
Groups: Registered
Joined: 4/28/2013(UTC)
Posts: 1
|
my washer fills up and then stops.I can hear the motor buzzing but it does nothing else. I found a similar post on this site where the washer would agitate but that's not my case at all.
I checked the pressure switch & tube, checked the belt. And the terminals on the wiring harness. I can turn the motor by hand in both directions. Any ideas?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 10/16/2012(UTC)
Posts: 3,806
Was thanked: 7 time(s) in 7 post(s)
|
Run it with front panel off and observe the motor. Is the motor shaft spinning (clip on bottom of shaft will rotate with shaft) but pulley not or is the motor shaft not spinning but motor just humming? Does it do this in both agitate and spin modes? Do you have a multimeter for testing?
Eric
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
