Customer Support 7 days a week

Welcome Guest! To enable all features please Login or Register.



Go to last post Go to first unread
#1 Posted : Thursday, April 18, 2013 7:46:23 AM(UTC)

Rank: Member

Groups: Registered
Joined: 4/18/2013(UTC)
Posts: 1

We had gotten error codes F2 and F3 which would then shut down the oven. We've read that these codes apply to the temperature probe or wiring. Now the codes have stopped and the oven will heat to 335 or so slowly appears only the top heating element is working. I replace the bottom element about 6 months ago as it had broken in half in one place and was obviously no longer working. The oven worked fine after that replacement until last week when the error codes started. My question it the temperature probe, the heating element (again) or something else. I also noticed that it appears the fan located at the rear of the oven is not working least I see no blade movement at all when the door is opened (and understand that it shuts off when the door is opened ...but would think there would still be some slow down movement. What steps / parts would you suggest. Thanks, Dave
See inside of your appliance - diagrams and part photos for virtually every model.

powered by
#2 Posted : Thursday, April 18, 2013 6:27:27 PM(UTC)

Rank: Advanced Member

Groups: Senior Expert
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 3 time(s) in 3 post(s)
Hello Dave,

Check the Bake (bottom) heating element for continuity.

If the heating element if good, replace the oven control board.

The fan on the back wall in the oven is for convection only and should work only when you use the convection cooking.

- The control board Part number: 318012901
Users browsing this topic
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.