Rank: Member
Groups: Registered
Joined: 12/9/2012(UTC)
Posts: 1
|
Two things not happening on this old model.
Dishes are not being clean, due to the spray arms not getting enough water pressure to circulate?? Not sure.
Also noticed motor and solenoid connections are showing Continujity, but not the water valve connections.
Is the water valve suppose to provide a reading, and if so, how? Could this be my entire problem??
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638
Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
|
Here are your parts. Parts for GE GSD1200X66 Dishwasher - AppliancePartsPros.comOpen the door just after the first fill. Is there water in the tub? Most units fill to just under the heater. Yes, the water valve should have continuity. Try a higher meter scale. If it still does not show continuity replace it, The tub should not get any water if the valve does not have continuity. Be sure to disconnect one side of the valve when measuring it. This prevents you from reading an alternate/parallel circuit path. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
