Customer Support 7 days a week

Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

New Topic Post Reply
Options
Go to last post Go to first unread
bilalian1  
#1 Posted : Wednesday, November 21, 2012 12:13:39 PM(UTC)
Quote
bilalian1

Rank: Member

Groups: Registered
Joined: 11/21/2012(UTC)
Posts: 2

My Kenmore slide in range does not reach preheat temperature. it takes an extremely long time and may reach 200 degrees at times, but sometimes not even that high. Broil works fine. I've replaced the lower element, and the thermostat, but the problem remains. I've tested the temperature sensor element, and it meets the resistance indicated on the site. What else could it be? The bottom element also does not appear to get hot. The cook-top works just fine
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
Simon / APP Team  
#2 Posted : Wednesday, November 21, 2012 12:25:27 PM(UTC)
Quote
Simon / APP Team

Rank: Advanced Member

Groups: APP Team
Joined: 2/12/2012(UTC)
Posts: 5,556

HI.

The model number you posted doesn't come up. Please check and re post.
Use the multimeter to check if there is 240VAC across the bake element, if not - trace the wire with out 120VAC up.

Simon.
bilalian1  
#3 Posted : Wednesday, November 21, 2012 2:06:36 PM(UTC)
Quote
bilalian1

Rank: Member

Groups: Registered
Joined: 11/21/2012(UTC)
Posts: 2

Thanks Simon - I tested the voltage. Across the element itself, I get 6 to 9 volts. However when I test from either side (with the wires attached) to the third wire from the outlet, I get 126 VAC. If I test from either side of the element to the other power wire, I get 240VAC. If I disconnect the wires, the yellow wire on the left side of the bake element has 6 to 9 VAC. I traced this wire to the back of the front control panel. Does this mean the control panel is bad, or has a bad integrated component. Also, I have trouble pulling up that model number as well. On this site, I've found it listed without the last 3 digits. So, 629.46795 is what was displayed after the last time I searched for parts. It's the correct number though, trust me.
Simon / APP Team  
#4 Posted : Wednesday, November 21, 2012 4:38:46 PM(UTC)
Quote
Simon / APP Team

Rank: Advanced Member

Groups: APP Team
Joined: 2/12/2012(UTC)
Posts: 5,556

Hi.

Based on the info you provided the control board should be replaced Part number: 5760M205-60
Part number: 					5760M205-60


Simon.
Quick Reply Show Quick Reply
Users browsing this topic
New Topic Post Reply
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.